Power-soak 34453 INSTRUCTIONS INSTALLATION PS-225 User Manual

PS-225 Installation Manual

6 Uncrating Remove From Crate Remove the Power Soak from the shipping crate. Sharp staples and nails are used to crate the machine and care must

7 Component Installation Lay the sink on its back to allow access to the bottom of the tanks. Be careful to not let the sink assembly drop on the f

8 Apply a generous bead of a drain sealant around the lip of the drain body. The

9 Using two nuts, attach the drain handle bracket to the studs on the bottom of the tank. Insert the drain valve handle through the bracket and into

10 Install Legs The Power Soak is usually shipped without the leg assembly attached to the machine. Different options have different types of le

11 Leg Set and Sink Insert the leg assembly into the sockets on the bottom of the sink. Insert the leg set into the sanitizer sink (sanitizer si

12 JBZ Joint Installation If the unit is shipped in one piece, skip this section. If the unit is shipped as two separate pieces, continue with thi

13 Bolt the channel rim and backsplash together using the nuts and bolts provided with the unit.

14 Wiring Connections Machine Wiring Locate the two halves of the wiring harness and inspect them to be sure they are clean and not damaged. Inser

15 Faucet Installation Open the faucet package and locate the water connection elbows, faucet body and escutcheon assemblies. Apply Teflon tape to t

16 Intentionally blank page

17 PS-225 Completing the Installation

18 Final Installation Steps Machine Placement Position the Power Soak so that the back splash rests against the wall and is placed according to the

19 Seal around the Backsplash and Screws Examine the installation to see that the wall and backsplash are clean and free of dust and oils. Seal the

20 Electrical Connections The final electrical connections between the Power Soak and the electrical supply must be made by a licensed electrician.

21 PS-225 Validating the Installation

22 Testing the Components Check for Leaks • Turn on the water supply and inspect all joints for leaks. • Close the drain valve(s), fill the sink(

23 Appendix

24 Power Soak is a registered trademark of Cantrell Industries, Inc. The Power Soak concept and design is fully patented. Power Soak Systems

Table of Contents Pre-Uncrating Checklist ... 1 Verifying System Requirements ...

Plumbing Connections ... 19 Electrical Connections ...

1 PS-225 Pre-Uncrating Checklist

2 Verifying System Requirements Prior to completely removing the Power Soak unit from the crate, it is necessary to verify certain requirements. R

3 Removal of Existing Unit If the new Power Soak is not replacing an existing sink, skip this section. If the removal of an existing sink is necessa

4 Pre-Plumbing Supply and Waste Lines The supply and waste lines must meet the following requirements: • Hot and cold water supply must be ½” dia

5 PS-225 Post-Uncrating Instructions