Owner's Manual PS-201
6 Preparing the System Filling the System At the beginning of each day or shift, fill the sinks with water that is metered to approximately the correc
7 Adding Detergents & Sanitizers Manual Chemical Dispensing After the sinks have been filled with water, add the proper amount of detergent and sa
8 Controls and Features Green Button Starts the washing action. If cycle does not start, refer to trouble shooting section. Red Button Stops the wash
9 Loading and Using the Wash Sink The Power Soak is a “random loading” system. This means that Power Soak items are not racked for washing. Instead,
10 Loading and Washing Utensils Each Power Soak system comes with a utensil basket that hangs in the wash sink. All utensils and other small wares sh
11 Sanitizing Pots & Pans After items have been properly rinsed they must be sanitized in the sanitizing sink. (last). It is necessary for each it
12 Wash, Rinse and Sanitizer Clean-Up Between each water change and at the end of each night, all tanks and drain boards should be thoroughly cleaned
13 Preventive Maintenance PS-201
14 The Power Soak machine requires minimal, routine preventive maintenance. As such, the following should be done on a routine basis to ensure that th
15 Troubleshooting PS-201
Table of Contents Introduction and Conventions ... 1 Product Introduction ...
16 Facility Owner/Manager Section The only troubleshooting procedure that the facility owner or manager can perform is listed immediately below. All o
17 Wash Pump/Heater Will not Operate After reviewing the status of the control panel LED’s, there is still an operating problem, refer to the followin
18 Authorized Service Agency Section Hazard to untrained or unauthorized personnel. The following procedures are provided for use only by an authorize
19 Wash Pump/Heater Will not Operate Refer to the previous checklist under the “Facility Owner / Manager Section” before proceeding to the following c
20 Prior to calling, please note the “Error Code” (if any) that can be identified by observing LED #2 on the UPM. If there is a control logic error, L
21 Installation PS-201
22 The installation and initial operational check of the Power Soak machine must be performed only by licensed and certified plumbers and electricia
23 A wiring diagram is located in the control panel enclosure on the machine. Specific part numbers and part information can be obtained from the fac
24 Power Soak is a registered trademark of Cantrell Industries, Inc. The Power Soak Design and concept is fully patented. Power Soak Systems. Inc. 90
Sanitizing Pots & Pans... 11 Drying of Pots & Pans ...
- Intentionally Blank Page-
1 Introduction and Conventions PS-201
2 Product Introduction Thank you for purchasing a Power Soak ware washing system. Your new Power Soak pot, pan and utensil washing system will provide
3 Explanation of Warning Messages Be sure to read, understand and follow all DANGER, WARNING, and CAUTION messages located in this guide and on the eq
4 Requirements for Detergents and Sanitizers Detergents Improper detergents will damage equipment! Use of the correct detergent in your Power Soak sys
5 Operating Instructions PS-201
Comments to this Manuals